Welcome to the MIDI Sprout forum

Author Topic: MIDI Sprout Kit Assembly Instructions  (Read 6021 times)

Offline sam

  • Sam
  • Moderator
  • Full Member
  • *****
  • Posts: 180
  • Understand How Your Tools Work!
    • View Profile
    • Electricity for Progress
MIDI Sprout Kit Assembly Instructions
« on: March 15, 2016, 09:45:57 PM »
    Instructions for assembling your MIDI Sprout Kit can be found at this
Link 

(you can find a super high resolution version of the instructions here!)

The assembly instructions provide step by step directions to build your MIDI Sprout Kit, showing component placement and wire connections on a breadboard. 

Please find below, three videos detailing the assembly of the MIDI Sprout Kit:
1. MIDI Sprout Kit Parts (Part 1) -

2. MIDI Sprout Kit Galvanometer (Part 2) -

3. MIDI Sprout Kit Final Build (Part 3) -


Parts List:

  • ATMEGA 328-PU preProgrammed with the MIDI Sprout software
  • LMC555 Timer
  • 10k Potentiometer (linear)
  • 47uF Electrolytic Capacitor
  • 0.1uF Capacitor (yellow)
  • 0.0042uF Capacitor (blue)
  • 100k Resistor (Brown Black Yellow)
  • 220 ohm Resistors x 7 (Red Red Purple)
  • 16 Mhz Oscillator
  • LEDs (2 Red, Yellow, Green, Blue, White)
  • MIDI 5 pin Connector
  • 1/8 input Jack (with 2 pin Header)
  • Solderless Breadboard
  • Snap Electrode Leads
  • Snap Electrode Pad Pairs x 3
  • Battery Pack (3 AA)
  • Jumper Wires x 20 (assorted)

Each kit comes with a preprogrammed ATMEGA328 microprocessor running at 16Mhz - more information about the MIDI Sprout Code can be found here.

[/list]
« Last Edit: December 08, 2016, 09:38:55 PM by sam »