Instructions for assembling your MIDI Sprout Kit can be found at this
Link (you can find a super high resolution version of the instructions
here!)
The assembly instructions provide step by step directions to build your MIDI Sprout Kit, showing component placement and wire connections on a breadboard.
Please find below, three videos detailing the assembly of the MIDI Sprout Kit:
1. MIDI Sprout Kit Parts (Part 1) -
2. MIDI Sprout Kit Galvanometer (Part 2) -
3. MIDI Sprout Kit Final Build (Part 3) -
Parts List:
- ATMEGA 328-PU preProgrammed with the MIDI Sprout software
- LMC555 Timer
- 10k Potentiometer (linear)
- 47uF Electrolytic Capacitor
- 0.1uF Capacitor (yellow)
- 0.0042uF Capacitor (blue)
- 100k Resistor (Brown Black Yellow)
- 220 ohm Resistors x 7 (Red Red Purple)
- 16 Mhz Oscillator
- LEDs (2 Red, Yellow, Green, Blue, White)
- MIDI 5 pin Connector
- 1/8 input Jack (with 2 pin Header)
- Solderless Breadboard
- Snap Electrode Leads
- Snap Electrode Pad Pairs x 3
- Battery Pack (3 AA)
- Jumper Wires x 20 (assorted)
Each kit comes with a preprogrammed ATMEGA328 microprocessor running at 16Mhz - more information about the
MIDI Sprout Code can be found here.
[/list]